Intended use
The PerfectTrim™ Tool is designed specifically to cut Mado shade fabric to match your window width during installation.
It should be used on a flat, stable surface, with the shade properly aligned and supported. The tool is intended for controlled, two-handed use, with steady downward pressure applied in a straight, guided motion.
The tool should not be used for any purpose other than trimming Mado shade material.
Proper use
Before trimming, confirm your measurement using the TrueFit™ Bar. The number shown on the bar is your fit number, and you will use that number as your cutting guide.
Locate the same number printed on the shade fabric. This is where the tool should be aligned before cutting.
Place the shade on a flat, stable surface. Position the PerfectTrim Tool at the edge of the shade and align the blade with your fit number. Ensure the tool is square to the fabric before beginning the cut.
Use both hands to hold and guide the tool. Apply steady, downward pressure and move the tool through the fabric in one smooth, continuous motion. The tool is designed to guide the cut when used this way. Do not twist, angle, or force it.
Trim both ends of the shade to the same fit number.
After trimming, check the fit of the shade against your window frame before proceeding with installation.
Safety guidance
The PerfectTrim Tool contains a cutting edge and should be handled with care.
Keep hands and fingers clear of the cutting path at all times
Always use the tool on a stable, flat surface
Use both hands to control the tool during cutting
Maintain control of the tool throughout the entire cutting motion
Store the tool safely when not in use
Improper use
The following are examples of improper use and should be avoided:
Using the tool for any purpose other than trimming Mado shade fabric
Cutting the shade while it is unsupported or on an unstable surface
Attempting to cut with one hand or without proper control of the tool
Applying uneven or excessive force, or angling the tool during use
Modifying, disassembling, or misusing the tool in any way
Use of the tool outside of its intended purpose or in a manner inconsistent with these instructions may result in damage to the shade or personal injury.
If you need help
If you are unsure about any step before cutting, contact Mado support. We are happy to walk you through the process before you proceed.